Daily Maintenance Guide for Hammer Mill

1.Before operating, appropriately precession the screw-cap-style oil cups on the bearing seat.If the lid has been rotated to the end, remove the lid, and fill up with butter and then install well.

2.After the machine works 200 hours, clean the bearing within the bearing seat.And clean the seal and oil cup. After washing, change the blankets, and paint with the new grease.

3. Before operations, check the V-belt’s tensioning situation.If it is loosen, tighten it.If the V-belt has been aged, replace it promptly. Or it will affect the overall performance.

4.After the mill working for some time, the hammer's sharp corner will turn to ground corner .And it will affect the working efficiency .At this time, flip all hammer for 180 degree.   Use other sharp corners of same side.And then use the same method with the other two sharp corners of other side .When the four sharp corners are rounded, replace them with new hammers.

5.After the Mill has worked for a period of time, sieve may have been worn or damaged due to various reasons.If the damage is not serious, it can be welded or riveted from the reverse side.   And if the damage is serious, replace the sieve timely.While replacing, firstly let the sieve skin and the ethmoidal meat us fit tightly. Then make hole onto the Screen terminal with the punch and the screw nut. And then fasten the sieve with the screws.

Note: The side with burr of Sieve Division should be down.

6.When the impeller wears seriously, it should be promptly replaced. And all the blades should be changed at the same time.In order to maintain the balance after the replacement of the impeller, please go to the manufacturer to buy the well balanced blades or impeller.

7.If the hammer mill does not work for a long time, please locate the equipment in the dry place for preservation.