Feed Machinery Information

• Why Choose Our Belt Type Silage Round Bale Wrapper Baler?

  完成

  Feed Machinery Information February 24, 2025
• Alfalfa Feed Pellets Making Mill/Making Alfalfa Pellets for Cattle Feed

  Advantages· Easy to store and transport. Alfalfa pellets have small size and light weigh, and low water absorbency.· Avoid the cattle dietary choosiness, and reduce food waste.· Have good palatability and increase feed intake.Disadvantages· As we all know, alfalfa has high nutrition, if cattle take

  Feed Machinery Information February 14, 2025
• Screw Type Oil Press

  What raw materials are suitable for pressing oil?Soybean, peanut, flax see, rape seed, tea see, sunflower seed, coconut,, rapeseed, sesame, walnut,olive,oil pine etc different kind of oil material. What are the preparations before starting up?(1) After installed, add lubricating oil , check whethe

  Feed Machinery Information February 14, 2025
• What Are The Advantages of PTO Bale Shredder?

  What are the advantages of PTO bale shredder?The cylindrical fully automatic straw crusher is a new type of fully automatic machinery. The cylinder is equivalent to an automatic feeding mechanism, which does not require a manual feeding rod. It can be fed into the cylinder with a forklift to powder

  Feed Machinery Information August 13, 2024
• Horizontal Cooler & Screen

  Horizontal Cooler & Screen Introduction for Pellet Cooler? The cooling drum screening machine is a special equipment for cooling and sorting particles. It is suitable for screening various feeds, wood chips and other materials. It has the characteristics of high screening efficiency, low noise, s

  Feed Machinery Information August 23, 2024
• After Reading This Article, You Will Choose Steam Corn Flaking Mill

  Digestion and absorption mechanism of steam corn flakesThe whole process technology is a process of starch gelatinization. The hydrogen bonds tightly bound to starch are destroyed by gelatinization, and the structure of protein is also changed. The corn is expanded and softened by steam heat process

  Feed Machinery Information August 23, 2024
• Daily Maintenance Guide for Hammer Mill

  1.Before operating, appropriately precession the screw-cap-style oil cups on the bearing seat.If the lid has been rotated to the end, remove the lid, and fill up with butter and then install well.2.After the machine works 200 hours, clean the bearing within the bearing seat.And clean the seal and oi

  Feed Machinery Information September 04, 2024
• Can The Oil Cake Left over From The Screw Press Be Profitable Again?

  After the oily raw materials pass through the screw oil press, there will be two parts, one is mainly edible oil and the other is oil cake.As we all know, edible oil has a wide range of uses and is more expensive.But many users do not know the use of residual oil cake. If the residual oil cake can a

  Feed Machinery Information November 04, 2024
• What Are The Functions And Uses of A Grain Suction Machine?

  Grain suckers are divided into two types according to the conveying method: 1.Suction and delivery type.2.Suction-only type.In the suction and delivery type, the wind carries the material into the machine through the suction device and the suction pipe, and the gas and material are separated by the

  Feed Machinery Information December 24, 2024
• Silage Harvester Balers: Machines Also Need Winterization!

  ●Product DescriptionThe newly developed silage harvester baler adopts roller-type grain crushing, with a crushing rate of over 98%, which can maximize the preservation of nutrients in silage, enhance its palatability and digestibility, and is highly economical. At the same time, it is equipped with

  Feed Machinery Information December 25, 2024